I was preparing 2 12400's for installation, 1 was clean installed with R77.1 and 1 had a used R77.30 installation on it.
I copied the deployment agent 1573 onto it, updated CPUSE and copied the Check_Point_R80.10_T462_Fresh_Install_and_Upgrade_from_R7X.tgz file, which I then imported.
Next step was installer clean-install <the imported package> and let it run and reboot.
All looked fine untill I was looking at the Mgmt interface, it had kept it's IP, and the default route and this is where it gets weird:
gw-7> show configuration static-route
set static-route default nexthop gateway address rt219bb100-100- on
I tried to add the correct route:
gw-7> set static-route default nexthop gateway address 100.100.219.9 on
RTGRTG0019 syntax error
With show route no routes are shown.
Adding any static route will just give me the same syntax error??
Regards, Maarten