Create a Post
cancel
Showing results for 
Search instead for 
Did you mean: 
Blason_R
Leader
Leader
Jump to solution

R80.10 Smartlog takes the current log only

Hi Team,

R80.10 smart console Logging and Reports Tab whenever opens it takes current fw.log only and I see the below filter is activated by default. Any idea why?

Please see the picture enclosed.

Thanks and Regards,
Blason R
CCSA,CCSE,CCCS
0 Kudos
1 Solution

Accepted Solutions
Dror_Aharony
Employee Alumnus
Employee Alumnus

This means you're in 'Non-Index' mode (replacing the Old/R77.x Smartview Tracker, but very similar = querying each log-files & fairly slowly).

 

Open your SA/Mgmt object > Logs > Activate Log-Indexing > Install database.

by default, if it's a Standlone Mgmt/GW or less than 4 CPU-cores, then it starts in Non-Index mode to avoid over-burdening your Server.

 

I assume your server can handle the R80.10 Log-Indexing (new SmartLog), then please activate it.

Good luck!

 

View solution in original post

0 Kudos
2 Replies
Dror_Aharony
Employee Alumnus
Employee Alumnus

This means you're in 'Non-Index' mode (replacing the Old/R77.x Smartview Tracker, but very similar = querying each log-files & fairly slowly).

 

Open your SA/Mgmt object > Logs > Activate Log-Indexing > Install database.

by default, if it's a Standlone Mgmt/GW or less than 4 CPU-cores, then it starts in Non-Index mode to avoid over-burdening your Server.

 

I assume your server can handle the R80.10 Log-Indexing (new SmartLog), then please activate it.

Good luck!

 

0 Kudos
Blason_R
Leader
Leader

I see maybe I need to see that. 

 

Thanks and Regards,
Blason R
CCSA,CCSE,CCCS
0 Kudos

Leaderboard

Epsum factorial non deposit quid pro quo hic escorol.

Upcoming Events

    CheckMates Events