What command has replaced cphaconf show_bond ?

[Chris_Thuys]

I recently upgraded to R80.20  and installed jumbo hotfix Take 17 and it appears that the command cphaconf show_bond   is no longer available. Does anyone know what has replaced it if anything  or alternative commands they provide the same information.

[Expert@xxxxxxxxxx:0]# cphaconf show_bond -a

                                      |Slaves     |Slaves |Slaves
Bond name  |Mode               |State |configured |in use |required
-----------+-------------------+------+-----------+-------+--------
bond0      | Load Sharing      | UP!  | 2         | 1     | 1
bond1      | Load Sharing      | UP   | 2         | 2     | 1
bond2      | Load Sharing      | UP   | 2         | 2     | 1

Legend:
-------
UP!               - Bond interface state is UP, yet attention is required
Slaves configured - number of slave interfaces configured on the bond
Slaves in use     - number of operational slaves
Slaves required   - minimal number of operational slaves required for bond to be UP

[Expert@xxxxxxxxxxxxxx:0]# cphaconf show_bond bond0

Bond name:      bond0
Bond mode:      Load Sharing
Bond status:    UP
Balancing mode: 802.3ad Layer3+4 Load Balancing
Configured slave interfaces: 2
In use slave interfaces:     1
Required slave interfaces:   1

Slave name      | Status          | Link
----------------+-----------------+-------
eth1            | Active          | Yes
eth1-01         | Not Available   | No

[Expert@xxxxxxxxxxxxx:0]#

[G_W_Albrecht · Accepted solution]

That is true - see Command Line Interface Reference Guide R80.20 p. 673:

Monitoring Bond Interfaces
Description: Shows the configuration of bond interfaces and their slave interfaces.

Shell: Gaia Clish
1. show cluster bond {all | name <bond_name>}
2. show bonding groups

Shell: Expert mode
cphaprob show_bond [<bond_name>]
cphaprob show_bond_groups

Where:
show cluster bond all
show bonding groups
cphaprob show_bond
Shows configuration of all configured bond interfaces

show cluster bond name <bond_name>
cphaprob show_bond <bond_name>
Shows configuration of the specified bond interface

cphaprob show_bond_groups
Shows the configured Groups of Bonds and their settings.