Hi,
I have issue very similar to the one described in older post (https://community.checkpoint.com/t5/General-Management-Topics/R80-10-Installation-Error-quot-doAutoP...) - i.e. I am getting exactly the same error message.
Differences are that this is a CP 4800 appliance and version I am going to install is R80.20.
I made USB few times using different versions of ISOmorphis as well as used USB-attached DVD - all the same.
Ran a HW Diagnostics Tool – all tests OK …
I was using ISO image “R80.20 Gaia Fresh Install for Security Gateway and Standalone T101” – the same image was used for installation of over 10 other gateways on 4000 appliances.
SHA1 checksum for the image is OK.
Any ideas?
I have none at this moment ... 😕
