Create a Post
cancel
Showing results for 
Search instead for 
Did you mean: 
Chinmaya_Naik
Advisor

Interface utilization on some interfaces (No Rx Over) (Recommendation)

Hi Team,

 

We come across to know that one interface is highly utilized.

Setup: 21400 Appliance with SAM Hardware (R80.10 OS)

4 SND and 8 Fw worker

Only FW , Identity Awareness and Monitor Blade Enable.

INTERFACE : 10G

Interface 10GInterface 10G

Utilization taken from CPVIEW (eth1-01 utilized more)

eth1-01 interface highly utiizedeth1-01 interface highly utiized

NO RX Over

Rx over.png

We can see the interface is highly utilized but NO Rx Over .

Kindly suggested a solution for this

Regards

@Chinmaya_Naik 

0 Kudos
2 Replies
Timothy_Hall
Champion
Champion

Please provide the output of ethtool -S eth1-01 for further analysis.

That interface seems to be handling the load just fine with negligible RX-DRPs and no other errors, what is your specific concern? 

Is that eth1-01 interface part of a bond and the traffic is not being distributed evenly between the physical interfaces of that bond of which eth1-01 is a part?  Can't really tell from what you have provided so far.

"Max Capture: Know Your Packets" Video Series
now available at http://www.maxpowerfirewalls.com
0 Kudos
Chris_Atkinson
Employee
Employee

Slight tangent here but which Jumbo version is installed and what are your acceleration stats like?

Note with R80.20 and above SAM cards are disabled and R80.10 will reach end of support in May 2021.

0 Kudos