Maestro 140 sync issue

[oscar790806]

Hi everyone

The customer has two Maestro 140 devices and two 6400 firewalls. Both MHO 140 devices need to be synchronized.

The connection is set up through the 1/48/1 ports on both devices, and the port status shows "up." However, after synchronization, both Member IDs are display to 1, causing sync issues. The orchestrator topology does not display the interface.

I have tried rebooting and orchd restart service, but the issue persists.

My version R81.20 Take 96

Has anyone encountered this issue before?

[Dario_Perez]

is possible you have wrong connected the gateway to both orch. 

Port 1 and 3 on gateway side are connected to MHO 1

Port 2 and 4 on gateway side are connected to MHO2

check lldpctl to confirm the PBethX-Y to confirm on each 

other possibility is any of MHO are wrong configured check orch_stat

set maestro configuration orchestrator amount, site,  and id. to confirm MHO 1 is 1 and MHO 2 is to and both have ammount 2 with same site amount and ID

[AkosBakos]

Hi @oscar790806 

This is a dual-site setup? If yes use eg.: 1/47/1 for site-sync

https://sc1.checkpoint.com/documents/Appliances/GSG_Maestro/EN/Topics/MHO-140-Front-Panel.htm

Port 48 (colored blue) is the Internal Synchronization port.

Akos