- CheckMates
- :
- Products
- :
- Quantum
- :
- Maestro Masters
- :
- Re: Maestro 140 sync issue
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Mute
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Maestro 140 sync issue
Hi everyone
The customer has two Maestro 140 devices and two 6400 firewalls. Both MHO 140 devices need to be synchronized.
The connection is set up through the 1/48/1 ports on both devices, and the port status shows "up." However, after synchronization, both Member IDs are display to 1, causing sync issues. The orchestrator topology does not display the interface.
I have tried rebooting and orchd restart service, but the issue persists.
My version R81.20 Take 96
Has anyone encountered this issue before?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
is possible you have wrong connected the gateway to both orch.
Port 1 and 3 on gateway side are connected to MHO 1
Port 2 and 4 on gateway side are connected to MHO2
check lldpctl to confirm the PBethX-Y to confirm on each
other possibility is any of MHO are wrong configured check orch_stat
set maestro configuration orchestrator amount, site, and id. to confirm MHO 1 is 1 and MHO 2 is to and both have ammount 2 with same site amount and ID
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi @oscar790806
This is a dual-site setup? If yes use eg.: 1/47/1 for site-sync
https://sc1.checkpoint.com/documents/Appliances/GSG_Maestro/EN/Topics/MHO-140-Front-Panel.htm
Port 48 (colored blue) is the Internal Synchronization port.
Akos
\m/_(>_<)_\m/
