Create a Post
cancel
Showing results for 
Search instead for 
Did you mean: 
Chinmaya_Naik
Advisor

"fw ctl get int fwha_perform_chain_forward" command failed

Jump to solution

Hi Team,

When I run the below command showing "Get Operation Failed".

"fw ctl get int fwha_perform_chain_forward"

 

Security Gateway OS : R80.30 (Take_196 JHF)

 

What is the use of this command ?

is this command not relevant in R80.30 ?

 

 

chain.png

 

Regards

@Chinmaya_Naik 

0 Kudos
1 Solution

Accepted Solutions
Guy_Elyashiv
Employee
Employee

Hi,

 

This command was used to enable or disable the "forwarding mechanism", this mechanism was deprecated in R80.20 and was replaced by a new mechanism called "correction layer" which is always enabled, therefore the commands mentioned are no longer available.

 


Regards,

Guy Elyashiv | Group Manager – Clustering & Multitenancy

View solution in original post

3 Replies
Guy_Elyashiv
Employee
Employee

Hi,

 

This command was used to enable or disable the "forwarding mechanism", this mechanism was deprecated in R80.20 and was replaced by a new mechanism called "correction layer" which is always enabled, therefore the commands mentioned are no longer available.

 


Regards,

Guy Elyashiv | Group Manager – Clustering & Multitenancy

View solution in original post

Chinmaya_Naik
Advisor

@Guy_Elyashiv

Thanks for the update.

How can I checked that "correction layer" is enabled.

is there any command or any file location ?

0 Kudos
PhoneBoy
Admin
Admin

It’s not a feature you can “disable” so it doesn’t make any sense to have a command to check the status of it.

0 Kudos