LOM stop accessing Resolved, TIP

[israelfds95]

If the LOM loses its configuration in the first wizard, and stops accessing.

Access via Gaia expert and reconfigure with the following commands::

ipmitool lan print 8

To see the current LOM configuration

In the case above, the Source IP address was with DHCP Address, and without IP

So with

ipmitool lan set 8 <press enter>

I looked at the parameters, changed IP address Source to static

So I configured the LOM's default IP again to have access to it again.

Other good commands

service ipmi start

ipmitool bmc reset cold

service ipmi stop

Clish Commands LOM

Bellow a good sk 

How to check the current LOM firmware version on Check Point appliances

https://support.checkpoint.com/results/sk/sk101250

[PhoneBoy]

Thanks for putting this together!