How to assign two interfaces to access a specific external interface

[f0d54525-c38c-4]

Hi there,

I have two internal interfaces ( Interface A and Interface B  ) and two external interfaces ( external C and external D). I want to set it as below:

1. Interface A access to the internet via external C
2. Interface B access to the internet via external D

As mentioned above, I tried to setup the PBR, but it does not work at all ( I am no CheckPoint r80.3 ), Appreciate your help.

[G_W_Albrecht]

I fear you will not receive any help from CP as R80.30 is out of support since September 2022 ! Also, it rather looks to me like you want to use one firewall instead of two firewalls !

[Chris_Atkinson]

Which JHF take is applied to the system and what configuration / PBR rules did you use?

[f0d54525-c38c-4]

Hi Chris,

I have just updated the latest version from 80.3 to 81.2. Could you guide me on how to do this?

[Chris_Atkinson]

At the very least source based routing should work here (also keep in mind how any NAT should look).

There are PBR examples in this knowledge article Policy-Based Routing and Application-Based Routing in Gaia (checkpoint.com) that can be adapted to suit your need.