Create a Post
cancel
Showing results for 
Search instead for 
Did you mean: 
mhmdmahdi
Contributor
Contributor
Jump to solution

Remote Access User can't access local network

Hi,

We just deployed new quantum spark 1600. We have done initial setup, add routing, and enable vpn remote access.

I can connect to the gateway using vpn, but cannot access to local network. This issue only happen when we use quantum spark, we have deployed the enterprise series (6200, 6600, etc) and the vpn is working fine. The connection to spark from local network and vice versa is good.

The network topology is:

Internet <-> SG1600 <-> L3 switch <-> local network

Are there any configuration I need to add?

 

Screenshot 2022-09-29 133250.pngScreenshot 2022-09-29 131858.pngScreenshot 2022-09-29 131824_.pngScreenshot 2022-09-29 131740.pngScreenshot 2022-09-29 131613.png

 

0 Kudos
1 Solution

Accepted Solutions
_Val_
Admin
Admin

Check that your RAV VPN users receive Office Mode, and that your internal networks route Office Mode IPs back to the Spark appliance.

View solution in original post

3 Replies
_Val_
Admin
Admin

Check that your RAV VPN users receive Office Mode, and that your internal networks route Office Mode IPs back to the Spark appliance.

mhmdmahdi
Contributor
Contributor

the remote user is getting ip from office mode, can ping to spark local interface ip address (192.168.20.5) but can't ping to L3 switch interface (192.168.20.6).

I'll check the route on L3 switch.

Screenshot 2022-09-29 144551.png

0 Kudos
mhmdmahdi
Contributor
Contributor

solved by adding route to office mode network on switch.

thanks for your support.

0 Kudos

Leaderboard

Epsum factorial non deposit quid pro quo hic escorol.

Upcoming Events

    CheckMates Events