R80 - SAM rules exception?

[Geomix7]

Hello All ,

I had enabled SAM rules and I want to place an exception ?

I tried to set the action to notify , but is not working .

Is there any other option?

Thank you

[PhoneBoy]

What precise steps did you take?
And what precise version/JHF level?
Note if this is Maestro/Scalable Platforms, SAM rules are not supported.

[Geomix7]

Hello PhoneBoy,

What precise steps did you take?

I open SAM rules through smart view .Then add new rule add source IP address - destination any - service any - action notify - expired never - enforce

I tried it on 2 different R80.40 environments .When I test this rule i see a new rule to override the previous once and placed an action reject. However, if i manual remove this reject entry automatically appeared the exception rule.

I don't know what cause this behavior. 

Any suggestions are welcome otherwise i will wait TAC and i will inform you accordingly.

Thank you