Create a Post
cancel
Showing results for 
Search instead for 
Did you mean: 
JeffS
Explorer

Absolute Beginners Guide to R80.x Installation problems

I tried - unsuccessfully to install GAIA and Smart Console using the instructions provided by Valeri_Loukine and ran into problems.  The installation seemed to work fine, but when I tried to run and GAIA, I kept getting a "403 Error"  I tried using both VMware Workstation 15 and VirtualBox, but was unable to connect.

Would appreciate any assistance.

My setup:

Microsoft Surface Book 2

16GRAM

500G HD

Running on wireless access.  Have a FingBox installed in network.

Tried different browsers - Edge, Chrome, IE, FireFox

 

I'm thinking that the IP addressing suggestions are what is screwing me up.. 

Thanks!

0 Kudos
6 Replies
HeikoAnkenbrand
Champion Champion
Champion

Hi @JeffS

Check this:

1) Connect via local VMWare connsole.

2) Login as 'admin'

3) Now set expert password 'set password <your expert pw>'

4) Login as expert user 'expert'

5) Disable firewall policy 'fw unloadlocal'

6) Check die IP address 'ifconfig'

7) Now ping your firewall from your notebook

If the ping works, it's a firewall problem. If the ping does not work it is a VMWare problem.

If you have a firewall issue check port 443:

# netstat -an | grep 443

and the HTTP prozess:

# ps - auf |grep httpd

If both points are ok >  check browser proxy settings and clear the browser cache.

 

 

➜ CCSM Elite, CCME, CCTE ➜ www.checkpoint.tips
HeikoAnkenbrand
Champion Champion
Champion

Hi @JeffS 

Sorry, I didn't read right that you were already logged in.

Please try to call the following link manually after login for the GUI portal.

https:///cgi-bin/home.tcl

or running the First Time Configuration Wizard again:

If for some reason the user needs to run the First Time Configuration Wizard again, then perform the following steps:

Important Note: If this machine was configured as Security Gateway, then it is not recommended to reconfigure it as StandAlone because after performing the below activity and configuring it as a Standalone you will see Security Management Server status as "Attention" in SmartView Monitor.

# expert
# rm -i /etc/.wizard_accepted
# rm -i /etc/.wizard_started
# reboot

 

You should have the following minimum requirements on VM:

- Gateway 4 GB RAM, minumum 1 core beter 2 cores
- Management 8 GB RAM, minimum 2 cores

➜ CCSM Elite, CCME, CCTE ➜ www.checkpoint.tips
Nick_Doropoulos
Advisor

Hi Jeff,

Could you also clear your brower's cookies and cache if you haven't done so already and try again?

 

0 Kudos
JeffS
Explorer

Cleared both.. didn't make a difference.

0 Kudos
Nick_Doropoulos
Advisor

What resources have you assigned to the Check Point VM Jeff? Also, is it a standalone deployment whereby it's both a manager and a gateway? Moreover, what sort of interface has it been assigned (bridged, host-only etc.)?

0 Kudos
Nick_Doropoulos
Advisor

In addition to my previous post, have you been trying to log into Gaia with http or https?

0 Kudos

Leaderboard

Epsum factorial non deposit quid pro quo hic escorol.

Upcoming Events

    CheckMates Events