I recently upgraded to R80.20 and installed jumbo hotfix Take 17 and it appears that the command cphaconf show_bond is no longer available. Does anyone know what has replaced it if anything or alternative commands they provide the same information.
[Expert@xxxxxxxxxx:0]# cphaconf show_bond -a
|Slaves |Slaves |Slaves
Bond name |Mode |State |configured |in use |required
-----------+-------------------+------+-----------+-------+--------
bond0 | Load Sharing | UP! | 2 | 1 | 1
bond1 | Load Sharing | UP | 2 | 2 | 1
bond2 | Load Sharing | UP | 2 | 2 | 1
Legend:
-------
UP! - Bond interface state is UP, yet attention is required
Slaves configured - number of slave interfaces configured on the bond
Slaves in use - number of operational slaves
Slaves required - minimal number of operational slaves required for bond to be UP
[Expert@xxxxxxxxxxxxxx:0]# cphaconf show_bond bond0
Bond name: bond0
Bond mode: Load Sharing
Bond status: UP
Balancing mode: 802.3ad Layer3+4 Load Balancing
Configured slave interfaces: 2
In use slave interfaces: 1
Required slave interfaces: 1
Slave name | Status | Link
----------------+-----------------+-------
eth1 | Active | Yes
eth1-01 | Not Available | No
[Expert@xxxxxxxxxxxxx:0]#