VSX Cluster error :Interface cannot be set. More than one default gateway is defined.

[Javier001]

Hello,

I´m configuring a new VSX Cluster with 2 bond interfaces, using Sync interface for state synchronization and Mgmt port as usual.

I received the following error:

Installing default Policy...

Successfully installed default policy ...

Generating VSX Configuration for VSX_CLUSTER

Pushing VSX Configuration to VSX_CLUSTER

FW 2: processed 9% of configuration...

FW 1: processed 9% of configuration...

Failed to configure VSX_CLUSTER with the following errors:

FW 2 :Interface cannot be set. More than one default gateway is defined.

FW 1 :Interface cannot be set. More than one default gateway is defined.

VSX Processing Completed with Errors

Operation has failed.

I only have one default router to switch gateway for each FW. Also, I have a LOM inteface with the same next_hop.

Thank in advances!

[HeikoAnkenbrand · Accepted solution]

Hi @Javier001 

Did you set a default route during the GAIA installation?

If so, delete them.

[Javier001]

Hi @Heiko
I can´t do that. Firewalls are behind many networks before reaching the MDS.

I have connected the Sync interfaces but one of them don´t have link detected...So I think that´s where the problems come from.

Is it possible build a bonding interface up with a Sync interface and a Eth interface?

Thank you

[_Val_]

Not related to sync. Still, you need to fix sync before moving forward.

[Javier001]

You are right. There was another static route configured not shown running "show route all" on clish. If you run from expert: clish -c "show configuration" | grep route, you can see ALL routes. Other way is cancel vsx mode using "vsx mode off" and then login on Gaia to see ALL routes.

Thank you.

[_Val_]

This looks like the issue described in sk101165

Please follow the SK to resolve. If it is still a problem, open a support case with TAC