Hi Guys,
I am deploying a VS in bridge mode between two switches and I need to form the OSPF between the switches but I am having issues.
In the VS side, I setup the following interfaces to form the bridge using smart console.
br10
- eth1.200 (trunk)
- eth2.200 (trunk)
br20
- eth1.300 (trunk)
- eth2.300 (trunk)
In the switch side, I configure an SVI per VLAN. Then I configure the physical port uplinks as trunk ports. This way, the OSPF is not forming and I do not see any traffic passing in the firewall.
However, when I configure the physical uplink ports of the switch to an access port for example access to vlan 200, the OSPF is forming and I can see traffic now in the firewall.
I would like to know what did I missed? The switchport should be working when I set it to trunk because my firewall interfaces are also in trunk mode as well.
