LOM for 6900 set IP

[Daniel_Kavan]

Hi,

Refresher onhow to configure the IP address, mask and gw of the LOM on a 6900 appliance.  There is no LED panel in front so I'm planning this.  We are on the command line but unsure of the commands.  Going in this way with admin / admin & putting in the ip address.   Working on the syntax now.

Connect a serial terminal emulator to the serial console port using the following parameters:

Baud rate: 9600
Data: 8 bit
Parity: none
Stop: 1 bit
Flow control: none

Connect a 10/100/1000 Mbit Network cable to the Console port.

1. Log in to console with these credentials (assuming the user did not change the 'admin' password):
   
   User: admin
   Password: admin
   
   
2. was able to set up eth1 for INT access (SSH & web ui)

3. set lom ip-address trying to figure out how to get to the LOM console

[Daniel_Kavan · Accepted solution]

sk92986

[Expert@HostName:0]# lomipset <LOM_IP_ADDRESS> <LOM_NETMASK> <LOM_DEFAULT_GW_ADDRESS>