Create a Post
cancel
Showing results for 
Search instead for 
Did you mean: 
Daniel_Kavan
Advisor
Jump to solution

LOM for 6900 set IP

Hi,

Refresher onhow to configure the IP address, mask and gw of the LOM on a 6900 appliance.  There is no LED panel in front so I'm planning this.  We are on the command line but unsure of the commands.  Going in this way with admin / admin & putting in the ip address.   Working on the syntax now.

 

Connect a serial terminal emulator to the serial console port using the following parameters:

Baud rate: 9600
Data: 8 bit
Parity: none
Stop: 1 bit
Flow control: none

Connect a 10/100/1000 Mbit Network cable to the Console port.

  1. Log in to console with these credentials (assuming the user did not change the 'admin' password):

    User: admin
    Password: admin

  2. was able to set up eth1 for INT access (SSH & web ui)
  3. set lom ip-address trying to figure out how to get to the LOM console

0 Kudos
1 Solution

Accepted Solutions
Daniel_Kavan
Advisor
sk92986

 

[Expert@HostName:0]# lomipset <LOM_IP_ADDRESS> <LOM_NETMASK> <LOM_DEFAULT_GW_ADDRESS>

View solution in original post

0 Kudos
1 Reply
Daniel_Kavan
Advisor
sk92986

 

[Expert@HostName:0]# lomipset <LOM_IP_ADDRESS> <LOM_NETMASK> <LOM_DEFAULT_GW_ADDRESS>

0 Kudos

Leaderboard

Epsum factorial non deposit quid pro quo hic escorol.

Upcoming Events

    CheckMates Events