Hello Experts,
I want to migrate from Cisco Router to a Checkpoint Device.
My challenge; how do i interpret the following config from Cisco Router on the Checkpoint Network Management Interface;
interface GigabitEthernet0/0
no ip address
ip flow ingress
duplex auto
speed auto
!
interface GigabitEthernet0/0.1
encapsulation dot1Q 1 native
ip address 10.10.10.1 255.255.255.0
ip flow ingress
!
interface GigabitEthernet0/0.40
description ***-VOIP***
encapsulation dot1Q 40
ip address 172.31.125.1 255.255.255.0
ip flow ingress
ip nat inside
ip virtual-reassembly in
ip policy route-map VOIPEXCH
!
interface GigabitEthernet0/0.100
description ***f-staff***
encapsulation dot1Q 100
ip address 192.168.100.1 255.255.255.0
ip flow ingress
ip nat inside
ip virtual-reassembly in
ip policy route-map LAN
!
interface GigabitEthernet0/0.101
description ***staff-2***
encapsulation dot1Q 101
ip address 192.168.101.1 255.255.255.0
ip flow ingress
ip nat inside
ip virtual-reassembly in
ip policy route-map LAN
!
interface GigabitEthernet0/0.102
description ***Guest***
encapsulation dot1Q 102
ip address 192.168.102.1 255.255.255.0
ip access-group GUEST in
ip flow ingress
ip nat inside
ip virtual-reassembly in
ip policy route-map LAN
Please how can i implement this sort of vlan on Checkpoint??
Thank you.
