Creating new vlan sub-interface on Cluster

[mrbob]

Hi,

I have a problem creating a new cluster IP on a VLAN sub-interface that I been banging my head against. Management is on a R80.30, 2 OpenServer nodes with R80.10. 

Both nodes have existing eth5 - trunked interface - with VLAN sub-interfaces working fine.

• Added a new sub-interface to both nodes
  • node1:
    • add interface eth5 vlan 46
    • set interface eth5.46 ipv-address 192.168.x.2 mask-length 20
    • save config
  • node2
    • add interface eth5 vlan 46
    • set inteface eth5.46 ipv-address 192.168.x.3 mask-length 20
    • save config
• created VLAN on the switches, allowed on all tagged ports
• logged on the gateway web GUI, the interfaces are marked as up and looks normal.
• verified that I can ping .2 and .3
• added Cluster interface in SmartDashboard
  • gateways & servers -> doubleclicked on the clusterXL resource -> network management
  • actions -> new interface
    • network type : cluster
    • ipv4: 192.168.x.1 / 20
    • member IPs: added node01 and node02 ipv4 addresses and mask-length
    • clicked OK to create
  • clicked Get Interfaces -> Get Interfaces With Topology
• in SmartDashboard the interface now looks identical to other sub-interfaces
• did a policy install, no errors.
• unable to ping 192.168.x.1 from
  • server on different VLAN
  • from both gateways
  • from a server placed on the VLAN with .x.1 as gateway
• checked 'cphaprob -a if' and it does not list the interface. other cluster interfaces are listed.

What step have I missed? why doesnt 'cphaprob -a if' show the new cluster IP?

Any help appreciated!

[_Val_]

Most probably those new VLAN interfaces are still unknown to the fw kernel.

Run fw getifs & fw ctl iflist

If your new VLAN not in the list, reboot the GWs one by one.