Checkpoint 5400 does not boot up. cli is blank.

[kraghkher]

I had a checkpoint 5400 HA in a distributed setup with running very well until I one of the gateways became unresponsive, left the cluster and no interface IP's were reachable. I proceeded to reboot with my console cable in, and then I noticed 4 beeps at power-on and the console stays blank with only "Zf6" displaying.

I've tried booting from an emergendisk created from the working Gateway but nothing happens. The same 4 beeps and blank screen.

Any pointers to what the issue might be and how to resolve it?

[PhoneBoy]

Sounds like an RMA is required.
Engage with the TAC.

[Timothy_Hall]

Yep, beeps with no console output normally indicates a Power On Self Test (POST) failure of some kind.  Usually a memory problem but could be just about anything hardware-related.  RMA time.

[kraghkher]

Thanks guys, I'll do just that.