- Products
- Learn
- Local User Groups
- Partners
-
More
Join Us for CPX 360
23-24 February 2021
Important certificate update to CloudGuard Controller, CME,
and Azure HA Security Gateways
How to Remediate Endpoint & VPN
Issues (in versions E81.10 or earlier)
IDC Spotlight -
Uplevel The SOC
Important! R80 and R80.10
End Of Support around the corner (May 2021)
Hello
Does anybody know – is it possible to change Cluster operation mode from HA to Load Sharing mode without downtime?
Are there any additional steps required besides changing mode on configuration page?
Regards
Andrey,
it is not possible to change the mode without downtime,
Sync between the members is lost and is started newly again. Before you change the cluster mode you have to decide which mode do you want to run. Multicast ore unicast ?
You have to check with your switch capabilities which mode you should use. Unicast is almost the mode with which most of the switch vendors has no problems. With multicast you're switches and routers attached to the cluster should support these.
Wolfgang
Wolfgang
According your reply - downtime will be min, right? It takes a few seconds for changing mode, isint it?
No need to reassemble cluster again, right?
Normally this should be changed quick.
Last time I did in my lab environment I had to reboot both nodes. And again be aware of the multi- or unicast mode, this ist the most to observing part.
Wolfgang
Thanks for answer.
We're using R80.20 with latest jumbo. Think there are no problems to change Cluster mode witch having lates jumbo
About CheckMates
Learn Check Point
Advanced Learning
WELCOME TO THE FUTURE OF CYBER SECURITY