Hi Guy!
Currently I have some confusing problems as follows:
1. I am configuring Remote Access on Check Point with Public IP set on Peplink and we change from port 443 -> 8443. This means that Peplink is configuring NAT as follows:
Public IP:8443 -> Check Point:8443
In addition, on Peplink there is also NAT port UDP 4500 & 500 for IPsec.
And this works fine.
2. When we enabled blade Mobile access, the Visitor Mode was forced to change back to 443, and we changed the configuration on Peplink to:
Public IP:8443 -> Check Point:443
However, at this time, Remote Access does not work. I'm not sure what the difference is here. Because it still runs over IPsec. But Mobile Access work ok!
Am I missing any other configuration on Checkpoint?
