license maestro

[Wolfgang]

Hello Checkmates,

how about licensing of the individual appliances in a Maestro environment.

Do I have to follow How to apply a license on a Maestro Security Gateway - Offline Procedure for every appliance, this is a manual process ?

How about the contract files, should it be added too and how about if a new subscription starts ?

How about later added appliances if there a different subscription dates ?

If one of the aplliances has no subscription for a specific blade but other has, are these blades deactivated on this appliance and not enforcing these security features?

( we had this problem because of a problem in Check Points license center )

Thanks

Wolfgang

[Maarten_Sjouw · Accepted solution]

You have to apply each license to each and every appliance, on top of that when you have a faulty license on a box, it is also stored on the SMO, so you need to remove every license that you need to delete with the g_cplic del <key> command, otherwise it will be back within 10 minutes.

For contractfiles I would expect the same goes there, also when a subscription is extended. On top of that when you use VSX and you want to use any of the blades, the VS0 need access to the internet to check on the contracts.

When you have an appliances that is not following the rules, for instance when you have VSX and 1 of the appliances has 2 licenses on it, one with and one without the VSX balde  added, you cannot install any policy to that security group untill you resolve this issue, same for a license with any HA reference will not allow installation untill it is removed.

When one appliance has no license for a specific blade, to my knowledge it will just not work on that appliance.

[Machine_Head]

Thanks for this.. Was banging my head against the wall seeing the license return every minute!!

[ma_gorkhali]

Hello @Maarten_Sjouw ,

I am facing issue while trying to renew the license.

sk163323 - Solutions for license issues on Maestro Security Appliances

Is this the correct SK to renew it as well or this SK is just used to add it in the new maestro box.

[Sven_Glock]

In my environment fetching licenses after configuring a proxy is working sometimes, but somehow it is now working always.

Especially when adding new sgms to an existing security group with VSX I already had some strange behavior when automatic pull is not working as expected. 
The new sgm stuck in pulling vsx config or trapped in some kind of boot loop.

So my recommendation is to add license manually.