R80.40 dynamic_split enabled or disabled?

[HeikoAnkenbrand]

How can I recognize if dynamic_split is enabled or disabled?

I can only find the following commands to change the mode.

# dynamic_split

      -o disable      -> Disables the CoreXL Dynamic Split. Requires a reboot.
      -o enable       -> Enables the CoreXL Dynamic Split. Requires a reboot
      -o start           -> Starts the CoreXL Dynamic Split after it was stopped. This change survives the reboot-
      -o stop            -> Stops the CoreXL Dynamic Split. This change does not survive the reboot.

Is there a command to display the status?

---

For more information to dynamic_split, see

- R80.40 Performance Tuning Administration Guide - Chapter CoreXL 
- R80.x - Performance Tuning Tip - Dynamic split of CoreXL in R80.40

[Matthias_Haas · Accepted solution]

"dynamic_split -p" should do this ?

[Expert@FW1-R8040-1:0]# dynamic_split -p
Dynamic Split is currently off
ALPHA: 10
EMERGENCY_CPU_HANDLING_THRESHOLD: 40cpview

cpview -> SysInfo is also displaying the status: