silent agent installation via GPO

[GB007]

Hi,

how to install again on workstations using GPO in silent mode

and also before installing check if already install

only if not install than push this silent installation

Thanks, 

[PhoneBoy]

Silent install can be done as follows: https://supportcenter.checkpoint.com/supportcenter/portal?eventSubmit_doGoviewsolutiondetails=&solut...
Checking if the client is already installed can presumably be done by checking the registry or similar. 

[mjain10]

the link mentioned above is not working. I am looking to install Harmony Endpoint EDR silently using a Deployment Software Package. Thank you. 

[Mark_Papworth]

There used to be (Pre-R80) a way to create a customized deployment package for VPN Clients where you could include the answers to the installation questions, such as authentication scheme, adding sites, advanced settings and even language selection and personalizing the client with a company logo.

Is this available for R81 or the latest VPN Clients? All I've found is the VPN Client configuration utility, sk122574, but it´s not the same.

[the_rock]

I will ask one of my colleagues about it tomorrow, as Im fairly sure he did this for the client recently, with the new E81.xx client.

Andy

[mjain10]

Either this link is not working or it is not available to me. could you please attach the actual document here? thanks. 

[PhoneBoy]

This link worked prior to the introduction of our new support site.
In any case, these are standard MSI installer commands to the best of my knowledge:

• msiexec.exe /i <location of msi>\EPS.msi /l*v install.log /qn /quiet /norestart
  (Silently install the MSI. When the install is done you will get a popup to restart or to postpone.)
• msiexec.exe /i <location of msi>\EPS.msi /l*v install.log /qn /quiet /forcerestart
  (Silently install the MSI with a forced reboot after 90 seconds)