Reverse proxy not working and still hitting manual NAT rule

[ajsingh]

Hi All,

I have a cloudguard HA solution in Azure tenant with R81.10 + 50 Jumbo on it. 

I want to configure Reverse proxy on my firewall and was following https://support.checkpoint.com/results/sk/sk110348 

Unfortunately i encountered two issues:

1. $CVPNDIR/conf/ReverseProxy_conf/ReverseProxyConf.xml gets reset every time i push configuration with ReverseProxyCLI apply config. Seems like same issue as this : 

https://community.checkpoint.com/t5/Remote-Access-VPN/Reverse-Proxy-dest-path/m-p/210485#M10485

2. Traffic is still hitting that manual NAT rule instead of the Reverse proxy Rule that i created . Has anyone encountered this before? I have opened case with TAC but no response yet.

Any suggestion would be helpful here.

Regards

AJ

[PhoneBoy · Accepted solution]

What precise rules are you discussing?
Screenshots (with sensitive details redacted) would be useful.

Not sure you can combine NAT and ReverseProxy (which might be the issue).

[ajsingh]

I think I will use Manual NAT rules instead. But thank you everyone for replying. I think so too that its preferring NAT rules over Reverse proxy rules.