AnsweredAssumed Answered

Interface Bonding Problem

Question asked by Charles Hurst on Mar 30, 2018
Latest reply on Mar 30, 2018 by Charles Hurst

Hey guys,

 

Just struggling a bit in my lab currently studying for my CCSA and in order to move forward I have a requirement to create a DMZ zone however due to lack of interfaces I am having to VLAN this using a Cisco Switch. I've configured CluserXL therefore (I believe) I need to use LACP to active active the trunks. I've setup the Cisco side and this has taken my ports down due to not having LACP configured on the Check Point side.

 

I figured that I need to create a Bond via GAIA and then I read somewhere else online about creating Bond VLAN's on top. 

 

The problem is that I don't seem to be able to remove the the IP from the interface in order to create the bond. The error just states:

 

KERLAG0029 Interface eth1 has IP addresses configured.

 

However prior to this I have set to DHCP, I've ran delete interface ETH1, restarted the gateway, updated all these changes through SmartConsole.. Still the same:

 

The interface shows as:

 

Interface eth1
state on
mac-addr 08:00:27:48:56:50
type ethernet
link-state link up
mtu 1500
auto-negotiation on
speed N/A
ipv6-autoconfig Not configured
duplex N/A
monitor-mode off
link-speed Not configured
comments
ipv4-address Not Configured
ipv6-address Not Configured
ipv6-local-link-address Not Configured

 

So I'm a little bit stuck and unable to find anything from my trusty friend google... Any help would be appreciated!

 

Thanks,

 

Charles 

Outcomes