- Products
- Learn
- Local User Groups
- Partners
- More
The State of Ransomware Q1 2026
Key Trends and Their Impact
Good, Better, Best:
Prioritizing Defenses Against Credential Abuse
AI Security Masters E7:
How CPR Broke ChatGPT's Isolation and What It Means for You
Blueprint Architecture for Securing
The AI Factory & AI Data Center
Call For Papers
Your Expertise. Our Stage
CheckMates Go:
CheckMates Fest
Just tested these expert mode commands on eth1 interface using vmxnet3 driver, and it worked to reset the counters for that interface:
ifconfig eth1 down;ifconfig eth1 up
This should also work:
ifdown eth1;ifup eth1
Can't vouch for whether the above commands will work with igb/ixgbe/mlx* drivers, if they don't try these WHICH WILL CAUSE AN OUTAGE ON ALL INTERFACES USING THE IGB DRIVER in this example, use at your own risk:
modprobe -r igb; modprobe igb
Then you will need to manually re-up all relevant igb-based interfaces like this to get them working again:
ifup eth0
ifup eth1
ifup eth2
etc....
About CheckMates
Learn Check Point
Advanced Learning
YOU DESERVE THE BEST SECURITY
