atp command and more on Autonomous Threat Prevention commands

[Don_Paterson]

The Threat Prevention Admin Guide seems to have no reference to the atp command.

I discovered and used 'atp status' command but cannot find anything interesting on it.

A reboot was the fix but still not sure what caused the ATP SmartConsole error.

See attached.

References:
https://sc1.checkpoint.com/documents/R81.10/WebAdminGuides/EN/CP_R81.10_ThreatPrevention_AdminGuide/...

https://supportcenter.checkpoint.com/supportcenter/portal?eventSubmit_doGoviewsolutiondetails=&solut...

https://community.checkpoint.com/t5/Threat-Prevention/Autonomous-Threat-Prevention-service-is-down/t...

[PhoneBoy]

I do see a reference to atp commands here: https://supportcenter.checkpoint.com/supportcenter/portal?eventSubmit_doGoviewsolutiondetails=&solut... 
However, you're right: there doesn't appear to be any documentation on these commands.

[Don_Paterson]

Yes, it is referenced there but only to show 'atp restart', and nothing else (no links or explanations).

As expected the atp command, when it is run on it's own, shows the 'usage' but the documentation on it is nowhere to be found.

Thanks for getting back to me.

[Tal_Paz-Fridman]

More information is available in the ATRG for Autonomous Threat Prevention:

https://supportcenter.checkpoint.com/supportcenter/portal?eventSubmit_doGoviewsolutiondetails=&solut...

In the past the product name was Infinity Threat Prevention hence all the command are use itp.

I will ask for the SK to be updated to use atp.

[Don_Paterson]

Thank you 🙂

I knew it was previously itp but did not think to search itp status in Support.

I just ran 'autoupdatercli show' and noticed that ATP components all fall under the header 'product-name: itp' .
Small thing.

Regards,

Don