VSX and Bond interfaces going down after few hours

[Dilian_Chernev]

Hello mates,

I am fighting whit very strange issue - Bond interfaces going down after few hours after reconfiguring interfaces on virtual machines.

There is a cluster of two 19200 (R81.20 JHF92) hosts in VSLS with bond interfaces to Cisco switches with LACP and VPC.
After configuring two VSs - configured interfaces, vlans, routes, blank policy with any-any-allow, everything is fine.
The only thing is that no vlan's are configured on the switches, becaus these VSs are prepared to replace existing plain devices that have same IPs. So to make sure everything is ok till the date of migration, there is no trafic on interfaces of VSs.

So after 4-6 hours, most of the bonds became down, Cisco switches are saying that ports are disabled and there is no way to bring them back up. 
On CP side, bonds are with different Aggregator IDs and interface are "churned" and the only way to bring them up is to reboot appliances.

This happens 3 times till now, every time several hours after reconfiguring interfaces of VSs.

Opened a ticket after first time, but nothing usefull came out - only sk115516, but this not helping to prevent from happeing again.
There is nothing usefull in /var/log/messages

Does any one have simillar problems?
Any idea which log files to check or what debugs could be run? I am pretty sure this can reproduced.

Thanks,

Dilian

[AkosBakos]

Hi @Dilian_Chernev 

Intersting, strange behaviour

@churned: https://support.checkpoint.com/results/sk/sk169760

One of the peer's LACP (etherchannel) interfaces is suspended or is otherwise no longer active as an LACP interface.

@Cisco side bond:

The bond ID is the same on the newly generated LACP and the existig one? Is there anything common on the existing switch config and the  new one?

Akos