Create a Post
cancel
Showing results for 
Search instead for 
Did you mean: 
Rodrigo_Mezetti
Participant

Dear,  I-am use R80.10 cluster .My vpn through endpoint security was running normally, until I needed to activate ipsec on the cluster to proceed with a serial connection to the site with azure. It happens that now my client who are using the endpoint, needing to reconnect every time access was done, where he places the destination IP, user and makes the connection. If I try to reconnect it informs that it is loading new topology and disconnects, then I need to redo the tunnel again. Can you help me

0 Kudos
Reply
1 Solution

Accepted Solutions
KennyManrique
Advisor

Most likely the fact you had to enable IPsec VPN modified the Link Selection properties previously applied.

You can check the following SK to force Remote Access VPN through one address sk92383

View solution in original post

2 Replies
KennyManrique
Advisor

Most likely the fact you had to enable IPsec VPN modified the Link Selection properties previously applied.

You can check the following SK to force Remote Access VPN through one address sk92383

View solution in original post

Rodrigo_Mezetti
Participant

Worked perfectly. Thank you very much