Static Route is not applied

[mallayiotis]

Hi all,

We are experiencing an issue with a static routing in our GW R77.30.

We have already a routing for the subnet 192.168.X.X/16 to go through destination A and we have added a new routing for the subnet 192.168.Y.X/24 to go through destination B but the new routing is never applied. All traffic is going through destination A.

We believe that the issue is related with the routed service.

Can anyone assist?

Kind Regards,

[PhoneBoy]

This should probably be a TAC case.
However, R77.30 is End of Support, so if it is a bug and it's not fixed in the last jumbo hotfix, your only recourse will be to upgrade to a supported version.

[Timothy_Hall]

Is the next hop for 192.168.Y.X/24 a valid responding IP address located on a directly-reachable subnet/interface?  If not you can configure the route but it will never be added to the live routing table unless the next hop can be directly and successfully reached; you cannot add a route with a next hop address that is reached through some other router and have it work, the next hop must be local.