Reboot After Expansion Line Card Installation

[prashanth]

Hi There,

   I have a requirement to slot in a new line card for CheckPoint 28000.
After adding the new line card, Do I need to reboot the gateway?

https://sc1.checkpoint.com/documents/Line_Cards/Content/Topics/Line-Cards/Line-Cards.htm

I found this document for the replacement of the line card. I'm not sure this applies to adding new line cards.
Furthermore, the model I'm looking for is not mentioned in the list.

Thanks in Advance

[Chris_Atkinson · Accepted solution]

You power down the gateway before installation of the new NIC card/s.

[Dolev]

I see the main question was answered, in regards to the guide, you can use this one.

https://sc1.checkpoint.com/documents/Appliances/FRU_Line_Cards/Content/Topics-FRU-Line-Cards/Introdu...

Which does contain 28000.

[prashanth]

@Dolev @Chris_Atkinson Thanks a lot for your inputs
I have a 28000 cluster and just to confirm the procedure I need to follow is as below

1. Shutdown the secondary node
2. Insert the line card
3. Power back the unit
4. Failover the cluster
5. repeat steps 1-3 on the primary node
6. Failback the cluster

Correct me if I'm wrong

Thank You in advance

[Ildar07]

Hello. 

Did you manage to add a network card? Is this procedure correct?

[Chris_Atkinson]

The documentation and this thread covers the basics steps involved to get a NIC ready for use.

It does not include all the steps for actual configuration of the interfaces/topology etc