- CheckMates
- :
- Products
- :
- Quantum
- :
- Security Gateways
- :
- Ping Gateway Script
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Mute
- Printer Friendly Page
Are you a member of CheckMates?
×- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Ping Gateway Script
Whenever we do any work on a gateway we have to do various health checks especially when rebooting a gateway. One simple check that is important is pinging the next hop gateways. We do this before and after a change to make sure that something didn't break such as an interface going into error disabled on a switch...which tends to happen.
This is a one off script that determines all of the next hop gateway addresses based on the routing table (via ip route) and attempts to ping them. If it fails to get a response it will check the ARP table to see if there is an ARP entry. It will give the process about 20 seconds per and then kill the attempt so the process doesn't take forever.
We use this script to capture results nightly as well so we know how it is supposed to look on a regular basis.
#!/bin/bash## [Ivan Moore]## Determine all next hop gateways from routing table and ping# to make sure we can reach them. If no ping response is received# check ARP table to see if we have L2 just in case the device is# not allowed to respond.## 11/19/2015VERSION=1.0.1# Program name: ping script to ping next-hop addressesdateip route | awk '/via/ { print $3 }' | sort -u | while read outputdo ping -c 1 -w 1 "$output" > /dev/null if [ $? -eq 0 ]; then echo "node $output is up" else echo " " echo "node $output is down" echo "Checking for an ARP entry in case PING is disabled:" arp -a $output & TASK_PID=$! sleep 20 kill $TASK_PID >/dev/null 2>&1 echo " " fidone