Create a Post
cancel
Showing results for 
Search instead for 
Did you mean: 
Prime
Contributor

How to configure SNMP V3 on checkpoint firewall

I want to configure SNMP V3 on checkpoint firewall.
I have configured firewall in 3 different VSX instances.
Firewall GUI is not available in VSX mode to configure, kindly check attached screenshot for you reference.

 

0 Kudos
4 Replies
Maarten_Sjouw
Champion
Champion

You begin with:
set snmp agent-version v3-Only
set snmp mode vs
set snmp agent on

Then to configure a user:
add snmp usm user <user> security-level authPriv auth-pass-phrase <PW-Auth> privacy-pass-phrase <PW- Privacy> privacy-protocol AES authentication-protocol SHA1

For VSX there are some more options, you can access the VS itself by it's own IP or access all through the VS0 IP with the following command:
set snmp vs-direct-access on/off
To make sure you are allowed to access each VS the following command is used:
set snmp usm user <user> vsid all/<VSID's>

Hope this helps.
Regards, Maarten
0 Kudos
Prime
Contributor

Any posibilities to do SNMP configuration through smart console?
0 Kudos
Maarten_Sjouw
Champion
Champion

Nope, not possible, only through the WebUI or CLISH and on VSX only through CLISH.
Regards, Maarten
0 Kudos
Prime
Contributor

As you suggested, we did the configuration on checkpoint Gateway. Now checking the device discovery SNMP status with NMS team.
0 Kudos

Leaderboard

Epsum factorial non deposit quid pro quo hic escorol.

Upcoming Events

    CheckMates Events