Create a Post
cancel
Showing results for 
Search instead for 
Did you mean: 
Adity12
Collaborator

Does anyone have tried to bonding interface checkpoint security gateway with mode LACP

Hi All,

 

i have concern to implementation LACP on Security Gateway.

 

the concern is should i must set target of bonding interface security gateway has applied LACP or no?

 

example:

there is one cluster with 2 member:

let's say FW1 and FW2, under this cluster there is an IPS dedicated with HA.

 

If FW1 has bonding eth3 - eth4 and another side FW2  has bonding same interface like FW1.

The question is, should i must set LACP on Mcafee or if Mcafee don't support LACP, can i use switch to receive interface LACP from cluster checkpoint and then from switch go to Mcafee1 and 2.

 

Hopefully my explanation is clear, if not i will send that topology.

Note: i have tried this mode between 6800 appliance series with standalone configuration and connected to 1800 appliance quantum spark, two this appliance has applied  LACP configuration.

 

Thanks Regards

Dio Aditya Pradana

 

0 Kudos
1 Reply
Chris_Atkinson
Employee Employee
Employee

LACP is common for load-sharing type Bonds (amongst other available modes) but you should align the configuration with what the adjacent device supports/expects 

Refer:

https://sc1.checkpoint.com/documents/R81/WebAdminGuides/EN/CP_R81_Gaia_AdminGuide/Topics-GAG/Bond-In...

CCSM R77/R80/ELITE
0 Kudos

Leaderboard

Epsum factorial non deposit quid pro quo hic escorol.

Upcoming Events

    CheckMates Events