- CheckMates
- :
- Products
- :
- Quantum
- :
- Security Gateways
- :
- Re: Configuring the ISP redundancy
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Mute
- Printer Friendly Page
Are you a member of CheckMates?
×- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Configuring the ISP redundancy
I have an appliance 3000 running GAIA R80.10 and would like to configure ISP redundancy. My question is, is it possible to have this setup in this appliance ? the documentation does not have that much information.
waiting for your responses.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Yes, instructions are in the ClusterXL Admin Guide.
ClusterXL R80.10 (Part of Check Point Infinity) Administration Guide
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks for the guide its really helpful. I have just discovered that the first gateway was not configured in cluster. Is it possible to change it and make it primary without starting the configurations again?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Just set the cluster member you want as primary with a higher priority (or adjust the other one with a lower priority).
This is done in the cluster object under Cluster Members.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks for the info. I was able to work on the redundancy. looking out for another checkpoint project.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Are you able to reduce the redundancy? how did you actually do it? I want to do the same.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I configured mine as load balancing not primary and secondary. its able to share the load. Can you give me more details on your configuration?
