- Products
- Learn
- Local User Groups
- Partners
- More
CheckMates Fifth Birthday
Celebrate with Us!
days
hours
minutes
seconds
Join the CHECKMATES Everywhere Competition
Submit your picture to win!
Harmony Mobile 4:
New Version, New Capabilities
As YOU DESERVE THE BEST SECURITY
Upgrade to our latest GA Jumbo
CheckFlix!
All Videos In One Space
Hello Guys,
We have a checkpoint 15400 appliance clustered and we are having an issue with the standby cluster member.
We noticed that our standby cluster member is using the virtual IP to communicate with outside instead of its own IP
Note: This issue started yesterday earlier it was working fine .
Any way to resolve this?
Thanks in advance.
I would suggest to try fwha_forw_packet_to_not_active
, a magical parameter:
Problem accessing standby cluster member from non-local network
Try with just entering # fw ctl set int fwha_forw_packet_to_not_active 1 on both nodes, and if it hepls, enable on permanent basis in fwkern.conf.
Hey did that in the first place didn't workout. Any other suggestions?
Thank you for replying Aleksei mentioned the same discussion article so i checked it but it didn't work.
Does this issue have to do with your NAT configuration? Are you NAT'ing everything behind the cluster address as it is being sent out to the internet? Also here is another SK sk107432
About CheckMates
Learn Check Point
Advanced Learning
YOU DESERVE THE BEST SECURITY