Create a Post
cancel
Showing results for 
Search instead for 
Did you mean: 
Danielcher
Explorer

replacing 1470 cluster with 1800s

Hi all,

 

I'm preparing to replace the older 1470s cluster with an 1800 cluster. 1470 runs R77.20.

 

Is there a step-by-step document for how to migrate all configurations and policies?

Any recommendations or special considerations that I should note will be much appreciated.

 

Thanks in advance

0 Kudos
7 Replies
_Val_
Admin
Admin

Locally or centrally managed?

0 Kudos
Danielcher
Explorer

Centrally managed

0 Kudos
_Val_
Admin
Admin

Also, did you try searching the community before asking? I think, it was discussed multiple times, for example: https://community.checkpoint.com/t5/SMB-Gateways-Spark/Configuration-transfer-between-different-SMB-...

 

Chris_Atkinson
Employee
Employee

Please see sk170162 depending upon your management configuration per Val.

0 Kudos
G_W_Albrecht
Legend
Legend

Only the TP rules should need some changes, as 1500 Gateways have a unified profile for IPS, Anti-Virus, Anti-Bot and Threat Emulation. 14xx have 2, an IPS and an Anti-Virus, Anti-Bot and Threat Emulation profile.

CCSE CCTE SMB Specialist
0 Kudos
the_rock
Champion
Champion

Everyone gave you very good answers. I would definitely keep in mind show configuration command, as thats probably your best bet. I know in below link, it states backup can be restored between different appliances, if they are on same version/HFA, but thats definitely easier said than done, due to mismatch in interfaces, hardware, network, OS parameters

https://supportcenter.checkpoint.com/supportcenter/portal?eventSubmit_doGoviewsolutiondetails=&solut...

 

 

0 Kudos
G_W_Albrecht
Legend
Legend

This is a post about Embedded GAiA - so sk170162 applies. Embedded GAiA has a show config command instead as explained here: https://community.checkpoint.com/t5/SMB-Gateways-Spark/Configuration-transfer-between-different-SMB-...

CCSE CCTE SMB Specialist
0 Kudos