- CheckMates
- :
- Products
- :
- Quantum
- :
- Remote Access VPN
- :
- can't upgrade client from E86.20
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Mute
- Printer Friendly Page
Are you a member of CheckMates?
×- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
can't upgrade client from E86.20
Hi,
We are running endpoint vpn client E86.20. We’ve been trying to upgrade to different new versions and always end up with the same issue, the client can’t connect right away. We have to retry several times and it eventually connects.
When it fails to connect we see this in helpdesk.log;
Service was stopped (in clean_trac_cb -> about to exit)
And we see this in Windows System Event log;
The Check Point Endpoint Security VPN service terminated unexpectedly. It has done this 1 time(s). The following corrective action will be taken in 0 milliseconds: Restart the service.
Any ideas what could be the cause?
Client is E86.20 on Windows 10 21H2. Gateway is R80.40 JHF take 192
Thanks
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Ok, so I think this is continuation from your other post. Question...does this happen to every single user?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
the client having issue connecting after upgrading the client, yes everybody we try to upgrade has the issue.
The issue were client are getting disconnected, only some users. One in particular who gets it constantly.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Does not sound like a compatibility issue, since I run newer client on windows 11 even and works just fine.
Maybe have a look at below, its possible there might be anti virus causing this...
Andy
