Create a Post
cancel
Showing results for 
Search instead for 
Did you mean: 
Megha
Explorer

Endpoint Security E84.50 Client Issues - Routing table different from specified Encryption Domain

Hi Checkmates,

We have upgraded our firewalls from R77.30 to R80.30 two years ago.
Since then we are facing issues accessing our system when connected over VPN using the newer versions of VPN client. E84.50

The only client version that works fine is the R73 endpoint connect.

There are two main issues we face with the new clients:
1. The VPN connected successfully, however we are not able to access the gateway itself, using the Mgmt IP or any other subnet.
      Example: We have configured 10.150.181.0/24 on the gateways.
                        VIP - 10.150.181.1, FW1 -10.150.181.2, FW2 - 10.150.181.3.
once connected to the VPN using the new client, we cannot access FW1 using 10.150.181.2.

2. The routing table, when connected to the new VPN client is different from the subnets defined in the encryption domain for Remote access.
       Example: In the encryption domain, we have defined 10.150.181.0/24, however the routing table post connecting to the client shows the below: (note: these subnets/ hosts are not defined anywhere in our firewalls/ smartconsole)

10.150.181.32 /32
10.150.181.36 /30
10.150.181.40 /29
10.150.181.48 /30
10.150.181.52 /30a
10.150.181.56 /32.... etc 

we have raised a support ticket but unable to get any meaningful feedback.. Has anyone here faced any similar issues??? Or know what could be causing this? Would greatly appreciate your help!

0 Kudos
(1)
1 Reply
OVN
Explorer

I would also like an answer to this question.

0 Kudos

Leaderboard

Epsum factorial non deposit quid pro quo hic escorol.

Upcoming Events

    CheckMates Events