Problems with Show Package tool

Kai_Magnussen · ‎2020-02-11

I have a slight issue with exporting rulesets from a R80.30 environment, with jumbo t50 installed.

After exporting either all rulesets at once, or just a single policy, only uid will be shown inside groups, or in networks.

That means the customer will then have to click further into these uids to disclose the full information, which is a bit troublesome.

The problem looks similar to the one posted here:

but, that post says it should be fixed since r80.20m2.

Any input to this would be appreciated.

PhoneBoy · ‎2020-02-11

Did you try pulling the latest version of the tool from github ?

Kai_Magnussen · ‎2020-02-12

hi,

Im looking into that now..will hopefully schedule a session with the customer, and install the latest version

Kai_Magnussen · ‎2020-02-13

hi,

So we are now going to install the latest version of show package tool.

is there a decent guide or some other documentation i can follow, in order to do this correctly, and hopefully quick?

_Val_ · ‎2020-02-13

Did you review sk120342 already?

_Val_ · ‎2020-02-13

there are full instructions listed there

Kai_Magnussen · ‎2020-02-13

hi,

Thanks. So, just need to download and run the mvn clean install and build as described.. will give this a go next week.

Are you a member of CheckMates?