Create a Post
cancel
Showing results for 
Search instead for 
Did you mean: 
Satya2021
Contributor

No mdsstat output

After mds restore, no output showing

Please see screenshot

 

 

 

 

0 Kudos
8 Replies
genisis__
Leader Leader
Leader

Silly question have you actually done a clean installed as a MDS then restored the data?

Satya2021
Contributor

Yes I have done fresh clean install and then restored 

the_rock
Legend
Legend

Are you able to see output of any command at all? Does mdsstop / mdsstart work?

0 Kudos
Satya2021
Contributor

Yes mdsstop;mdsstart work fine

Have attached screenshot and pls check that all CMA are showing properly

0 Kudos
the_rock
Legend
Legend

You may wish to check with TAC. I had not worked with P-1 in some time, so little bit rusty on it, but that sounds like it could be a potentially some sort of corruption, because it makes no sense that command would not give you an output...it would be literally equal if cpconfig did not work on gaia fw command line.

0 Kudos
Satya2021
Contributor

I got the issue as Leading interface was changed from mdscofig

 

 

the_rock
Legend
Legend

Ah, good point!!

0 Kudos
genisis__
Leader Leader
Leader

that makes sense!

Leaderboard

Epsum factorial non deposit quid pro quo hic escorol.

Upcoming Events

    CheckMates Events