DAIP on Second WAN Interface

[Pedro_Romero]

  I have a gateway with 3 WAN interfaces,

WanA, WanB and WanC

WanA has a public static IP address which is used as the IP in "General Properties" under which the gateway object was created...

WANB currently has a public static IP address; but now I need to change that to a Dynamic Address, I am trying to edit the network topology but I do not see an option to have a DAIP interface on that WanB....

How do I do this on the Network Topology from SmartConsole ¿? ¿?   

Any suggestions or help will be greatly appreciated

[PhoneBoy · Accepted solution]

That’s not possible unless you tick the relevant option in the General tab.
Not sure if this still applies, but in R77.x anyway, gateways could not use certain Threat Prevention features and/or Identity Awareness if a gateway was DAIP.
Possible there are a few other limitations.

See also: https://supportcenter.checkpoint.com/supportcenter/portal?eventSubmit_doGoviewsolutiondetails=&solut...

[Pedro_Romero]

Thankyou very much, I needed to confirm if this was posible or not..... very greatfull.