Maestro VSX - Configure same vlan id on different bond / VS

[Cristian_F_CCSM]

Hello, in a Maestro enviroment with VSX, we need to configure one bond dedicated to VS 1 (bond 1) and one bond dedicated to VS 2 (bond 2). The two bond will be connected to different network switch and these switches use the same vlan id linked to different networks.

Therefore, the follow configuration:

- VS 1 bond1.100 192.168.100.1/24

- VS 2 bond2.100 192.168.101.1/24

is fully supported with Maestro and VSX?

Thanks

[Dario_Perez]

if you need to use the same VLAN over different VS then, create a virtual switch. 

virtual switch can be leaded to "n" vs's

[Cristian_F_CCSM]

Hello, in our case we can't use virtual switch feature because the vlans use the same id but are linked to different networks. Thanks

[Dario_Perez]

if they are different segment maybe you can set one interface as access port in switch and other as vlan tag. 

other solution is use a different VRF. 

you can use the same VLAN on different VRF

[Cristian_F_CCSM]

Hello, in our case the VRF feature will be executed with CP VS.

On network switch side VRF isn't useful because we heve two different and indipendendt switches.

Regards.

[Dario_Perez]

did you try VLAN translation? other option is pass a Access Port

[Cristian_F_CCSM]

In our case work with access ports aren't possible because the vlan in overlapping are tens.

Regards

[Dario_Perez]

but you say they comming from different switch no?

[Cristian_F_CCSM]

Hello, yes I confirm

[Bob_Zimmerman]

VLAN IDs are only locally significant on an interface. I know of no reason this wouldn't work.

[emmap]

If they are different VLANs but with overlapping tags, this will work fine.