cancel
Showing results for 
Search instead for 
Did you mean: 
Create a Post

Set static VMAC on R80.20

Jump to solution

Hello everyone

I have the following doubt;

We are planning to migrate from R77.30 to R80.20 and we'd like to keep the same VMAC (value) on the Cluster configuration. Is this possible? Is there a way to configure it static?

Thank you,

Best regards

 
 
0 Kudos
1 Solution

Accepted Solutions
Highlighted

Re: Set static VMAC on R80.20

Jump to solution

Hi Ivory,

According to sk50840:

imagen.pngimagen.png

The way VMAC is generated differs on each version.Until the bit number 32, probably you will got the same value in case this is a non VSX system. You can try to "play" with Cluster ID value to get the last 16 bits remaining.

Regards.

0 Kudos
1 Reply
Highlighted

Re: Set static VMAC on R80.20

Jump to solution

Hi Ivory,

According to sk50840:

imagen.pngimagen.png

The way VMAC is generated differs on each version.Until the bit number 32, probably you will got the same value in case this is a non VSX system. You can try to "play" with Cluster ID value to get the last 16 bits remaining.

Regards.

0 Kudos