R81.20 Take 70 - API readiness test failed

[FireMage]

Hello everyone,

i know the take is not yet released. but all the positive reports have prompted me to install it anyway.
unfortunately this has not been a success so far. i get the same problem on 2 different vm's:

- the installation went without error and after the restart i could not find any error in the function in general

BUT

i then tried to log in via smart dashboard, which did not work.

Cause:
the api service has a problem

i have already tried several things and also searched the internet. unfortunately without success.

should i forget the whole thing for now and wait for the release or do you have an idea?

thanks
jeff

[the_rock]

I installed it on 5 lab devices and no issues, 2 of them mgmt servers. Can you run below command?

watch -d $FWDIR/scripts/./cpm_status.sh (ctrl+c to stop)

Andy

[FireMage]

hi andy,

looks good:

Check Point Security Management Server is running and ready

thx

jeff

[the_rock]

I know sometimes api may take bit of time to show successful, so can you try again? If you are able to, we can do remote later to check.

Andy