Check Point stops redistributing routes in BGP

[Hllrdm]

We had a problem that Check Point stopped broadcasting marshalls to BGP after a while. What could be the problem? At the moment it helps to change route redistribution repeatedly.

[Chris_Atkinson]

Can you please share some additional information...

Which version / JHF is the gateway, is the issue only when a failover occurs and is graceful restart configured?

Anything else that might be relevant?

[Hllrdm]

We use the R81.10 cluster. The latest JHF.
I misspoke. It helps if we delete the route from Route Redistribution and recreate it. We announce the default route.

[Chris_Atkinson]

Is it being redistributed from another routing protocol (e.g. OSPF) or static?

[Hllrdm]

Redistributions are made from a static route

[Chris_Atkinson]

Do you happen to have the output of the routing table when the issue is present, is the default route seen on the gateway and with what "rank"?

[the_rock]

I had this issue with customer maybe 2 years ago and after troubleshooting it for few hours, we finally decided to reboot the fw and that fixed the problem. It would have been nice to find out the reason in the first place, but since it was really late at night and everyone was tired, we just did not bother : - )

[Hllrdm]

We rebooted the cluster member, but the default route redistribution problem persisted

[Chris_Atkinson]

Did you manage to capture the output suggested above showing the routes/rank?

[Hllrdm]

Check Point publishes its route in BGP, I requested a routing table from the network department when we see a problem and when we don't

[the_rock]

Yes, please get that when you can, because we would need to see the difference.