Create a Post
cancel
Showing results for 
Search instead for 
Did you mean: 
C_M
Contributor

CLINFR0329

While trying to change passwords in clish I get the following errors:

CLINFR0329 Invalid command:'set user admin password

CLINFR0329 Invalid command: 'set expert-password

Please advise.

0 Kudos
8 Replies
Danny
Champion Champion
Champion

You either don‘t have the required permission to run these commands or you are not in Clish mode. Post a screenshot.
0 Kudos
C_M
Contributor

See attached screenshot.

0 Kudos
PhoneBoy
Admin
Admin

Leave off CheckPoint from both commands.
You will be prompted for the password you wish to use.
0 Kudos
PhoneBoy
Admin
Admin

If set expert-password doesn't work, you must be in an early version of Gaia.
The command should be set expert-password plain in that case.
set user admin password should work even in R75.40, though.
That said, you can also try set selfpasswd to change your password, assuming you are logging in as the admin user.
C_M
Contributor

R80.10

0 Kudos
Maarten_Sjouw
Champion
Champion

try to use the Tab key while typing: set user admin pass<Tab> and see if it fills it to password and then hit enter to enter your new password.
Regards, Maarten
0 Kudos
omar_1212
Explorer

Hey, 

I am new to checkpoint here. Did you ever find what was the issue for this  as I am stuck on this at the moment while trying to configure an out of the box checkpoint.

Thanks

0 Kudos
PhoneBoy
Admin
Admin

"Out of the box" please elaborate.
What hardware (if VM or Open Server, please specify the RAM/CPU/Disk allocated) and what version/JHF?

0 Kudos

Leaderboard

Epsum factorial non deposit quid pro quo hic escorol.

Upcoming Events

    CheckMates Events